Swift65 Build Guide Key note: This will not include full 100% step by step guide to assembling mechanical keyboards in general.
Information that will not be provided but you can look them up with these link!
Soldering switches into pcb
Testing PCB (Solder and Hotswap)
Lubing Stabilizers + Installation
Some keynote PLEASE READ:
You may or may not need Stablizer shims if you are using Durock screw in stabs (Need to install with O ring) or Tx1.2mm pcb stabs.
Some minority of customer reported that the screws on the case are quite tight, Please use proper hex tool/Allen Key to ensure smooth case opening experience
DO NOT TRY Untightening the case screw with the same hex tools over and over if they don't work, They will just simply strip the screw socket.
Step 0: Preparation. Ensure that your desk and workspace are clean and clear
Here are some parts you will be receiving
Step 1: Removing screws from the case for prep
Step 2: Sticking Gasket strips on the case
Step 3: Installing EVA Block on the Bottom case
Step 4: Testing your pcb (Refer to the top link) + Installing switches
Step 5: Assembly
Step 6: Closing back the case + Sticking rubber feet to the bottom case
Done!
Do contact us if you have any question we can help you with or contact Alfred on our community discord